On 2/8/2012 2:17 PM, Ian Jackson wrote:
In message , amdx
writes
Hi All,
I'm on a boat, about 170ft from the utility post.
Recently our cable company switched to the wonderful world of
Digital TV. I got the new digital converter and had no picture.
I took the box back and got a second box, still no picture. So now I
suspect a weak signal and confirm that it is the cable length. The
cable company came out and gave me a better cable than I had
installed. At this point I have a picture but it is intermittent. The
signal at the utility post has 3 outputs and had a four way splitter,
I suggested the cable guy put in two 2 way splitters and give me the
stronger (first) tap.
That got my signal to work almost all the time. I'd like to get the
signal to work 100% of the time.
I don't has access to electricity at the utility post, so an amp is
out. Although I could try an amp at the cable box end. Is that
reasonable?
I would run two cables if there was a way to make it increase signal
strength.
Getting anymore from the cable company is not an option.
Any ideas to get a better signal?
Mikek


PS.

When the signal fails it seems channel 41 is ok and above 42 it breaks
up.
Curious to know if there is an unusual frequency jump between those
two digital channels.


Despite your long 170ft drop cable, were you getting good analogue
signals before the change to digital? If so, it could be that something
is not right. Normally, even if you have had only fairly mediocre
analogues, the digitals are good.


But, analog can be snowy but very watchable, digital an be pixalated
and stuttering without no sound or often no picture at all.

Otherwise....
It sounds like your signals are just too weak. As things are, and if you
can, the obvious fix would be to overcome the substantial loss of the
170ft drop cable by fitting an amplifier at or near the utility post
(not at your end), and power it with low voltage via the coax from your
end (ie similar to a line-powered masthead antenna amplifier). However,
you would need to consult with the cable company to see if they were OK
with letting you do this. It could be that they might be able advise you
on the most suitable amplifier to use. It's not rocket science, but you
have to be a little careful not to break any of their rules and
generally do anything they don't approve of.

I had not thought about a coax powered amp, Thanks.
Mikek