Home |
Search |
Today's Posts |
|
#1
|
|||
|
|||
I read in sci.electronics.design that Richard Clark
wrote (in ) about '1/4 vs 1/2 wavelength antenna', on Thu, 3 Mar 2005: On Thu, 3 Mar 2005 20:53:48 +0000, John Woodgate wrote: Doesn't everyone know that an audio amplifier that id designed to feed an 8 ohm load MUST have an output source impedance of 0.0000001 ohms or less. Hi John, I hope that was a joke. If you read the whole paragraph, you will see. -- Regards, John Woodgate, OOO - Own Opinions Only. The good news is that nothing is compulsory. The bad news is that everything is prohibited. http://www.jmwa.demon.co.uk Also see http://www.isce.org.uk |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Discone antenna plans | Antenna | |||
The "TRICK" to TV 'type' Coax Cable [Shielded] SWL Loop Antennas {RHF} | Antenna | |||
Poor quality low + High TV channels? How much dB in Preamp? | Shortwave | |||
X-terminator antenna | CB | |||
Outdoor Antenna and lack of intermod | Scanner |