| Home |
| Search |
| Today's Posts |
|
|
|
#1
|
|||
|
|||
|
Hi -
I just got my hands on an old Grant XL and it looks like it's had a hard life. Can someone tell me the correct transistors for the Driver, Final, and pre-driver? Also, when I look at the inside with the SO239 jack facing away from me, I see the Final on the left, the driver on the right, and then the pre-driver hanging sideways on the back far off to the right? Is that the correct order? I'm trying to go from memory back when I had one of these rigs and it isn't going so well :-) I saw the VCO can was messed with when some idiot put in channels so I adjusted it and got the radio to receive and transmit now. But, there's no power output on the wattmeter. However, when I put my Walkie-Talkie nearby it got receive. So, I am convinced one of the three is shot; final, driver, pre-driver. I have seen that two of those three have been replaced previously...hmm. Any help? Thanks in advance! ShaggyDAdogg |
|
#2
|
|||
|
|||
|
Final = 2SC1969C
Driver = 2SC2166 or 2SC1308 Pre-driver = 2SC1973 AM Regulator = 2SD1135 or 2SC1419 Voltage Regulator = MB 3788 Go hear to see a block diagram of your unit. It helped me out lots trying to bring my ol' faithful back to life... http://thexlclub.tripod.com/block.html Take care... ONE37 ___________________________ To reply remove 'NOSPAM' "ShaggyDAdawg" wrote in message ... Hi - I just got my hands on an old Grant XL and it looks like it's had a hard life. Can someone tell me the correct transistors for the Driver, Final, and pre-driver? Also, when I look at the inside with the SO239 jack facing away from me, I see the Final on the left, the driver on the right, and then the pre-driver hanging sideways on the back far off to the right? Is that the correct order? I'm trying to go from memory back when I had one of these rigs and it isn't going so well :-) I saw the VCO can was messed with when some idiot put in channels so I adjusted it and got the radio to receive and transmit now. But, there's no power output on the wattmeter. However, when I put my Walkie-Talkie nearby it got receive. So, I am convinced one of the three is shot; final, driver, pre-driver. I have seen that two of those three have been replaced previously...hmm. Any help? Thanks in advance! ShaggyDAdogg |
|
#3
|
|||
|
|||
|
Excellent!
Thanks a bunch!!! |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| WANTED: Uniden Scanner BC002 CTCSS Tone Board | Equipment | |||
| WANTED: Uniden Scanner BC002 CTCSS Tone Board | Equipment | |||
| UNIDEN GRANT XL | CB | |||
| HELP: Uniden Grant mic socket help! | CB | |||
| SGC ADSP2 Board w/Uniden Grant XL | CB | |||