Home |
Search |
Today's Posts |
#9
|
|||
|
|||
Hello.
On my FT757GXmkI the VFO knob is a push-pull fit. It is a very tight fit and I've on guarantee that all the mkI sets were a push-pull fit - Yaesu might have changed partway through production. My 757 came with the "FT-757GX Technical Supplement" which shows how to take the set apart. Looks like you remove the top and bottom covers and then you'll see the screws which retain the front panel. I'm _almost_ certain that you don't have to remove the VFO knob in order to remove the front panel. I think the front panel comes away from the body of the set as a compete unit. I can scan the relevant page for you if that would help. 73, Ian G4EAN Anders S. Nielsen wrote in message . .. have recently bought a used FT-757GX (Original not MKII) - It works fine, but I need to clean/tighten the mode selector. How do I remove the front panel? Do I have to remove the VFO knob? Vy 73 de Anders / OZ3ACB |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Advice needed on HQ-100 | Boatanchors | |||
2m homebrew antenna advice??? | Boatanchors | |||
Advice Needed for Super J-Pole Design: Inductive Loops Overheating | Antenna | |||
Antenna advice - "Plastic Car" | Antenna | |||
TS450S: advice needed | Equipment |