Home |
Search |
Today's Posts |
#4
![]() |
|||
|
|||
![]()
On 6/2/2010 8:31 AM, Kevin W0KLH wrote:
I just reinstalled my Icom back into my vehicle after it being out for several months, I was listening to 20 meters yesterday and tried to get into a few of the pileups that were going on. A second or two in keying up to ID my call, the radio shuts off. I also have developed what sounds like a ground hum on VHF. For an antenna I am using a Yaesu ATAS-100 with a AM-COM controller. When tuning the antenna in, I get to very low SWR's on the meter, so I don't think that it is a high SWR that is causing it. I have checked all connections and they are tight, so any thing further I can check? Thanks Kevin w0klh Don't know if you have the head remoted or not. If so, the instructions are very clear about grounding of the plug on the back of the control head, or something that effect. Andy W4KDN -- Two most common elements in the universe- Hydrogen & Stupidity |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
FA:Icom IC-706MKIIG | Swap | |||
FS Icom 706MKIIG | Swap | |||
Icom 706MkIIG PL Tone Problem | Equipment | |||
Mobile Icom 706MKIIg shielding problem ? | Equipment | |||
Mobile Icom 706MKIIg shielding problem ? | Equipment |