| Home |
| Search |
| Today's Posts |
|
#1
April 4th 13, 03:21 AM
|
|||
|
|||
Kenwood TH-28A problem
I have a Kenwood TH-28A and have an extended antenna on the unit. I have been inside and outside to reach a repeater and have not had any luck. I have even hooked it up to my 2 meter outside antenna.
The settings that I have on it a - T S APO Then when I press the LOW button I then see the following: M. I then press LOW again then it switches to L Pressing Low for a third time shows: EL The repeater is set to take in negative. It is approximately 30+ miles away. I am at a loss as to what the problem is. Would someone know what the solution is? |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Kenwood R-5000 problem | Shortwave | |||
| Problem with Kenwood TS-570 Low Power on CW. | Equipment | |||
| Kenwood TS-520 problem | Boatanchors | |||
| Kenwood R-5000 problem | General | |||
| Help with Kenwood TS-820 VFO stability problem | Equipment | |||
Threaded Mode
