| Home |
| Search |
| Today's Posts |
|
#2
February 24th 05, 09:58 PM
|
|||
|
|||
"Justín Käse" wrote in message news:421e0983.1844693@chupacabra... I'm considering adding an IF filter to my 706, and am trying to decide between the 1.9kc or the 2.8kc width for use on SSB. Has anyone any experience with either/both? FL-103 2.8kc FL-223 1.9kc -- JK Not with the 706 per se, however you basically need to decide if you want decent quality or hi pitched un-natural voice. 2.8 is a good choice for a decent sounding SSB signal. 1.9 would be good for digging one out of the noise. If the 706 is switchable for those choices, get them both. Dan/W4NTI |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| FA: Kenwood Crystal Filters & Misc | Swap | |||
| Channel-based AM tube tuner (was Designs for a single frequency high performance AM-MW receiver?) | Shortwave | |||
| AOR AR8600MkII - SSB and AM Collins Filters | Scanner | |||
| Debugging of LC Bandpass Filters | Homebrew | |||
| Debugging of LC Bandpass Filters | Homebrew | |||
Threaded Mode
