Cutting non ferrous metals with a table saw

#21

December 19th 08, 03:23 AM posted to rec.radio.amateur.homebrew

Dale Parfitt[_3_] Dale Parfitt[_3_] is offline

external usenet poster

First recorded activity by RadioBanter: Jan 2008

Posts: 141

Cutting non ferrous metals with a table saw

Jimmie

Hey OM

did you looky at harbor freight tools?

I seen a twin blade circular saw $60 only

73 OM

n8zu

Commercially, we use a triple chip blade. The current blade is almost 10
years old and leaves a mirror finish on the aluminum cut.

Dale W4OP

Reply With Quote

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cutting D11 on Realistic TRC-492	Froggie	CB	12	September 15th 07 06:17 AM
BUY an auction house -- for precious metals	Al Patrick	Shortwave	0	March 4th 05 05:30 PM
I'm Cutting Back (OT)	Burr	Shortwave	14	May 3rd 04 10:34 AM
Cutting your own	Airy R. Bean	General	178	October 16th 03 01:27 PM
Cutting your own	Airy R. Bean	General	0	October 10th 03 10:47 AM

All times are GMT +1. The time now is 07:30 AM.

Menu

About Us