FireArcherIIc schrieb:

The antenna on my ICF-SW7600gr broke off inside the case. The rear
plastic holding the antenna in place weakened and snapped. I would like
to replace the Antenna with a short wire and clip to attach to other
antennas. Which solder point should I connect the lead wire to. There
are three places where the old antenna plate made contact. One was near
the AM bar antenna, and two were toward the side of the circuit board.
Thank you for any assistance.

The antenna is connected to a copper pad in the upper right corner of
the PCB:

http://www.loaditup.de/509903.html

HTH

Reinhard