Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Sony ICF-SW7600gr Antenna Repair
The antenna on my ICF-SW7600gr broke off inside the case. The rear plastic holding the antenna in place weakened and snapped. I would like to replace the Antenna with a short wire and clip to attach to other antennas. Which solder point should I connect the lead wire to. There are three places where the old antenna plate made contact. One was near the AM bar antenna, and two were toward the side of the circuit board. Thank you for any assistance.
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Replacement whip antenna for Sony SW7600GR | Shortwave | |||
Sony AN-LP1 Active Shortwave Loop Antenna - Battery Power and On-Off Switching with the Sony ICF-SW7600GR AM/FM Shortwave Radio. | Shortwave | |||
FS on ebay - Sony ICF-SW7600GR Radio & Sony AN-LP1 Active Loop Antenna | Shortwave | |||
Sony ICF-SW7600GR antenna jack | Shortwave | |||
Sony SW7600GR Antenna Question | Shortwave |