About Us

June 7th 05, 06:10 AM

In article ,
"Brian Hill" wrote:

"Telamon" wrote in message
..
.
In article . com,
wrote:

Good point from DK! These receivers are absolutely notorius for solder
joints that go bad over time. I have several friends with R-71As that
have had numerous solder connection problems over time but have been
able to fix them themselves. The radio is a "rat's nest" of cables and
wires inside unfortunately.

That's not the only radio with soldering problems. My couple year old
$4K Ten-Tec started dying on me after a few minutes of operation. It
would be working normally and then light for the signal strength meter
would go out, the meter would go to half scale and the audio would drop
out. That was to many things failing at the same time so I suspected
power supply problems. This radio has a status led for each of the four
power supply voltages and looking through the top grill sure enough I
saw one of them go out when the radio malfunctioned. Turned out to be
the +12V supply. Turned out that most of the solder connections on the
power supply output connector were cracked on the power supply board.

--
Telamon
Ventura, California

What Model is your Ten-Tec Tel?

RX340, the $4,000 buck radio with the $100 switching power supply that
runs to hot due to restricted air flow.

--
Telamon
Ventura, California

June 7th 05, 06:25 AM

In article . com,
wrote:

Solder problems seem to be the case in all the cheezy "yellow board",
single-sided consumer grade pc boards. I see it all the time in
cheap power supplies. If the boards have plated thru holes the
problem is almost non-existent.

It's a single sided board. You think the hole plating is going to help
relieve mechanical or heat stress? I think you mean an actual rivet
right?

A hole in a circuit board can have three types of through construction
in increasing order of duty:

1. Plated through.

2. A cylinder of copper inserted and then plated to the top and or
bottom pads.

3. A rivet of copper. The cylinder of copper is inserted in the board
longer than the board thickness and crimped to the board pads.

My descriptions are a little clumsy as I don't know the exact board
fabrication terminology.

I expect you mean #3.

These power supply manufacturing companies have a lot of tough
competition and try to figure a way to squeeze every penny out of the
cost of a supply.

--
Telamon
Ventura, California

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Breaker 1-9 good buddy! I got a Dead Leprechaun on my tail!	[email protected]	CB	0	December 9th 04 01:09 AM
Wanted Dead or alive Communications receiver,s and radio equipment	big boy now	Shortwave	0	November 27th 04 05:33 PM
ICOM R71A knob and collar needed	BDK	Equipment	0	December 17th 03 07:30 PM
ICOM R71A knob and collar needed	BDK	Equipment	0	December 17th 03 07:30 PM
r5000 or r71a	Jerry	Shortwave	21	October 18th 03 02:44 AM

Menu

About Us