Home |
Search |
Today's Posts |
#1
![]() |
|||
|
|||
![]()
Hi -
I just got my hands on an old Grant XL and it looks like it's had a hard life. Can someone tell me the correct transistors for the Driver, Final, and pre-driver? Also, when I look at the inside with the SO239 jack facing away from me, I see the Final on the left, the driver on the right, and then the pre-driver hanging sideways on the back far off to the right? Is that the correct order? I'm trying to go from memory back when I had one of these rigs and it isn't going so well :-) I saw the VCO can was messed with when some idiot put in channels so I adjusted it and got the radio to receive and transmit now. But, there's no power output on the wattmeter. However, when I put my Walkie-Talkie nearby it got receive. So, I am convinced one of the three is shot; final, driver, pre-driver. I have seen that two of those three have been replaced previously...hmm. Any help? Thanks in advance! ShaggyDAdogg |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
WANTED: Uniden Scanner BC002 CTCSS Tone Board | Equipment | |||
WANTED: Uniden Scanner BC002 CTCSS Tone Board | Equipment | |||
UNIDEN GRANT XL | CB | |||
HELP: Uniden Grant mic socket help! | CB | |||
SGC ADSP2 Board w/Uniden Grant XL | CB |