I dont have a ch 00 in the bank, they start say 301, 302 ect..

I can hear the channels analog side but when the freqs are set to trunk they
do not pick up anything.

I can get a 800 trunk II to trunk but not the EDACS..I called Uniden but
they are useless..
They dont even want to walk you through one program.



wrote in message
...
Do you have the frequencies entered in LCN Order starting in channel *01
(not *00) in the bank in question?


"John Walker" wrote in
news:nOn7j.15798$OR.5246@trnddc01:


Hey there guys -

I have a BC796D and I have set up the trunk section, control
channels...in order but it will not log a call
in the trunk mode and no IDs are shown..

I can only receive on each control channel, trunk off and I do NOT see
any IDs.

The system I am trying to monitor says its EDACS standard which from
what I read is EDACS-wide.
I have tried EDACS-narrow too..no luck with any ID information
trunking.

I can send screen shots as an attachment if someone would be willing
to look at the config.

Thanks
John