N9NEO wrote:
DUH!

You have to do full-wave rectification if you are going to use a
avaraging type of filter. Think about it.
The precision half-wave circuit that responds to peak should work well
also. I'll probably stick em both on the board.

73
NEO

Rob K2CU design goal limited the loading on the diodes.
D800 goes to the non inverting, very hi z, D801 goes to
the non inverting input of U6A and the gain is 1 so the
non inverted, now low Z, output goes to the inverting
input of U6A where the 18K resistor might give too much
loading. I built a simple, U6A less, version but it had
fairly high distortion. It sounded much worse then a
single diode detector.

In my wife's R2000 I went with a 0.001uF for the output filter cap.
For most SW/HF signals the tansmitted BW will be 5KHz. To
tell the truth the change from 0.0033 to 0.001 didn't make much
audiable difference. I didn't bother to make any tests.

For 455KHz IFs U6A/B will need to be changed. The LMC660 is
just not up to that higher freq. They do work fine at 50KHz.

The other improved AM detector with a single OpAmp works, but
diodes must be very closely matched. A simple DVD diode Vforward
will not suffice!

Petes AD607 synch detector has to be the simplest way to get going.
There are other approaches that might fare better. The SAD in the
R8B is much better then the AD607 or the AO7030+. Better as in
will never growl, and doesn't fo nuts with a strong adjacent signal.

The AD607 OpAmp fitler I/Q combiner page that I refferenced is well
worth the study. If done correctly, it is possible to exclude or reject
everything except for the desired signal.

The Synch detector group has some very interesting PDFs from
older approaches that go into the mind numbing math. I never got
the filter to work properly. There are no obvious typos, and the
design looks sound. When I run out of other projects I intend to
revisit this one because IF it can be made to work, the rejection
would be very useful.

My psuedo/quasi/faux "MAP"/SE-3 had several detectors. For reasons
that escape me I decided to add FM with a crystal discriminator. Works
great the 3 times I used it. Twice for 10M FM, and once for a Pirate on
6.925.
The least usefull part of my oatboard detector.

Terry