| Home |
| Search |
| Today's Posts |
|
#22
December 19th 08, 08:04 AM
posted to rec.radio.amateur.homebrew
|
|||
|
|||
Cutting non ferrous metals with a table saw
On Dec 18, 9:23*pm, "Dale Parfitt" wrote:
* Jimmie Hey OM did you looky at harbor freight tools? I seen a twin blade circular saw $60 only 73 OM n8zu Commercially, we use a triple chip blade. The current blade is almost 10 years old and leaves a mirror finish on the aluminum cut. Dale W4OP I just realized I worked 37 hrs of overtime in the last 2 weeks. I think I am going to treat myself to one of the triple chip blades. Jimmie |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Cutting D11 on Realistic TRC-492 | CB | |||
| BUY an auction house -- for precious metals | Shortwave | |||
| I'm Cutting Back (OT) | Shortwave | |||
| Cutting your own | General | |||
| Cutting your own | General | |||
![JIMMIE[_2_] is offline](https://www.radiobanter.com/images/SultanThemeVB3R/statusicon/user_offline.gif)
Threaded Mode
