Chip,
I totally agree with you about the difficulty in handling fine-pitch SMD
parts. It's a sign of the times.

FYI, check out the DDS Daughterboard at www.njqrp.org. This is a DDS
application board kit with on-board clock oscillator (you could run it from
an external oscillator if you wish). There's also a link to a service that
will solder your DDS chip to your bare board for $6 in single quantities.

Joe
W3JDR

"ChipS" wrote in message
...

"W3JDR" wrote in message
...
Take a look at Analog Devices' line of DDS chips. Pretty much a one-chip
(needs ucontroller to drive it) digital solution to turn your 10MHz
clock
into virtually any frequency below 5 MHz (in theory; below 4MHz in easy
practicality). The AD9834 only consumes 20mw at 3.3 VDC. There are many
other devices in the product line. Many have built-in comparators to
produce
square-wave output.

Joe
W3JDR



Joe, I'd gladly use the Analog Devices DDS chips if they offered them in
something other than a SadoMasochistic Device (SMD) package. It's a darn
shame they can't make a limited run (say 10k) of some of these chips in a
PDIP package for hams and other r.f. experimenters.

If they put the AD9835 in a PDIP and sold it for about $10.00 (the TSSOP
packaged version sells for about $6, I think) , I'd buy a dozen for
various
projects, but in the tiny SMD package they're nothing but useless to me.

I'm new to the newsgroup and am sure that this is not the first gripe
about
SMD's, but I refuse to use them - not because I can't (at least not yet),
but because I don't want to endure the angst.
--
Chip
KC5UES
real E-mail Address:







-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----