"Standard parts" for rf amps?

November 22nd 05, 12:40 AM posted to de.sci.electronics,rec.radio.amateur.homebrew,sci.electronics.components,sci.electronics.design

RST Engineering \(jw\)

Posts: n/a

"Standard parts" for rf amps?

You are going to use Spice to model an RF circuit. DId I get that right?

Jim

"Henry Kiefer" wrote in message
...
Hi all -

I'm not new to electronics but to vhf comm. I want to build small
circuits:
LNA, power amp to 10 watts, etc. At the moment between 10MegHz and
150MegHz.

What are the standard parts, cheap but effective, preferable with spice
model availability (I'm doing much with LTspice)?
Transistors, ICs, coil-suppliers, suppliers in general for small
quantities

Reply With Quote

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
this message is for keyclowns selling amps on ebay	Keyclowns are limpwristed	CB	15	December 15th 05 01:57 AM
Shunt feedback in broadband RF amps	[email protected]	Homebrew	15	November 1st 05 02:29 AM
Low noise -- op amps	K7ITM	Homebrew	0	January 7th 05 06:41 PM
Go Amps Go	SteveJ	CB	13	May 25th 04 02:05 PM
FCC to make CB Amps Legal again!	WA3MOJ	Policy	2	April 28th 04 04:07 AM

All times are GMT +1. The time now is 08:31 PM.

Menu

About Us