Home |
Search |
Today's Posts |
#2
![]() |
|||
|
|||
![]()
Lazy Senior wrote:
I recently acquired a Viking Ranger in nice working condx. I am interested in using this on AM on 160, 80, and 40 mtrs. The Ranger runs around 40 watts Am carrier output. I would like to get an amplifier to use with this xmtr, maybe a vintage amp. What should I be looking for? I would like to run legal Am Limit on these 3 bands. Should I forget about Vintage Amps and get a modern Amp? Suggestions please. Any pitfalls to using a modern Amp? Put the thing on the air as it is and have some fun. You can add an amp if you want, but give it a try with 40W and see how you do. I bet you'll be surprised. There are plenty of decent used linear amps out there if you want to go that route, but if you think about it in dB, 1000W isn't _that_ much more than 10W. Only a few S-units at the receiver. --scott -- "C'est un Nagra. C'est suisse, et tres, tres precis." |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Low noise -- op amps | Homebrew | |||
Go Amps Go | CB | |||
FCC to make CB Amps Legal again! | Policy |