| Home |
| Search |
| Today's Posts |
|
|
|
#1
December 19th 08, 03:47 AM
posted to rec.radio.amateur.homebrew
|
|||
|
|||
Cutting non ferrous metals with a table saw
Ian White GM3SEK wrote:
At last - someone using the right tool for the job You can get fine-kerf angle-grinder blades, that's what I use. They need frequent replacement, but for the occasional cut, it beats a hacksaw. |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Cutting D11 on Realistic TRC-492 | CB | |||
| BUY an auction house -- for precious metals | Shortwave | |||
| I'm Cutting Back (OT) | Shortwave | |||
| Cutting your own | General | |||
| Cutting your own | General | |||
Hybrid Mode
