| Home |
| Search |
| Today's Posts |
|
#18
December 7th 05, 07:20 PM
posted to de.sci.electronics,rec.radio.amateur.homebrew,sci.electronics.components,sci.electronics.design
|
|||
|
|||
"Standard parts" for rf amps?
Sorry. I found the needed file at CEL website by searching for part number.
- Henry "Henry Kiefer" schrieb im Newsbeitrag ... Thanks Saandy! I knew CEL but forget them ;-) Seems the NE85633 is really cheap and good performance. The package is reasoable for hobbyists. Do you already converted the parameters to spice and is it possible to provide the file to me? Thank you! Should be a good oscillator and all-purpose amp... Sure, plain wire is better than the manufactured coils if possible to apply. cu - Henry "Saandy , 4Z5KS" schrieb im Newsbeitrag oups.com... The NE85633 bipolar transistor from California Eastern Laboratories (CEL) ! very cheap quite stable and with a good noise figure. very well documented by the manufacturer! try to fish a development kit of SMD coils from Murata, sometimes they give them away for free. I personally prefer to go with air wound inductors, they're better and quite small at these frequencies. Saandy 4Z5KS |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| this message is for keyclowns selling amps on ebay | CB | |||
| Shunt feedback in broadband RF amps | Homebrew | |||
| Low noise -- op amps | Homebrew | |||
| Go Amps Go | CB | |||
| FCC to make CB Amps Legal again! | Policy | |||
Threaded Mode
