LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #32   Report Post  
Old January 8th 04, 05:43 AM
Telamon
 
Posts: n/a
Default

In article , "phil "
wrote:

hi Telamon:

how would you characterize these RX340 specs?

IP3: 5-kHz -53 dBm, 20-kHz +4 dBm


The 5 KHz number is not very good. The 20 KHz number is not bad. In
practice you might think I would have a problem listening to a weak
station with a strong station on the next channel over but I haven't
noticed it.

phase noise: -113 dBc/Hz


It would be nice if it was -120 down but it appears to be low enough
because the receiver noise floor can be 1uV.

ultimate rejection: 70 dB


It is supposed to be at least 70 dB but depending on how you use the
radio it is actually much greater so the ultimate selectivity is better
than this number makes it look.

--
Telamon
Ventura, California
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Icom 730 zero-beat question Michael A. Brown General 2 August 14th 04 12:57 PM
Icom 730 preventative maintenance question Michael Brown Equipment 4 April 26th 04 04:23 AM
Icom 730 preventative maintenance question Michael Brown Equipment 0 April 25th 04 05:46 PM
Newbie question: icom ic-r7000 Steve Uhrig Scanner 0 September 1st 03 06:01 PM
question ICOM PCR-1000 Tomislav Stimac Equipment 0 August 24th 03 10:59 AM


All times are GMT +1. The time now is 09:38 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017